KR-Electronics, насчет дров к кабелю 180лбе ори я ступил, всегда работал с усб. Так вот, сконектился с тел. уанНанд довнлоадером 1.4 тот мне рекомендовал тыкнуть 512М, после чего выдал: ---------------------------------------------------- ** Wait for Connect Request from Mobile... ** (POWER ON the PHONE!) ** Send '0x44' to SWIFT Chip ** Connection granted from SWIFT Chip ** Received 16 bytes from SWIFT chip ** Sending the customer ID and the same 16 bytes to SWIFT chip... OK! ** Try to change Timeout ! ** Ok! Timout Changed(1600 mSecond) ** Setting downloading address (SCRAM: 0x0C000000)... OK! ** Downloading the pre-Loader (1844 bytes)... OK! ** Set the start address of pre-Loader (SCRAM:0x0C000000)... OK! Start Pre-Loader... OK! Trying to change the baudrate... Change Baudrate 115200 -> 115200... OK! BB Chip version(1313) Downloading the Boot-Loader (184744 bytes)... OK! Jump to Boot-Loader (RAM:0x18000000)... OK! Sending the base address of CS0 (0x10000000)... OK! Checking FLASH ID... Detected (KBJ10KB00M),OneNandID(24) ** Now you can do the followings. ** 1. Download the BINARY and/or TFS files 2. Dump NOR-Flash 3. Erase NOR-Flash 4. Format Nand-Flash 5. Dump TFS files 6. Check the status of NAND-Flash ---------------------------------------------------------------- Мне нужно кричать БИНГО!! ? снимаю дам - примерно по времени около 2х часов занимает (хочу сначало родное тело спрятать подальше), но батарейки не хватает, как только она разряжается (как я понял), снятие дампа прекращается или просто очередной вис? и чем лучше работать для заливки и снятие? Спасибо.